Silva S15 Spécifications télécharger pdf (Page 11)

Operation Manual S15

Page

Note that the radio will not transmit, nor will alternative channels be able

to be selected while in dual watch mode. To restore normal operation

press

(F)

key again or press channel

(16)

key.

4.2 FULL SCAN (FS)

This function scans through each channel sequentially until a signal is

detected above the squelch level set. Once the signal ends or drops

below the squelch level, the radio will continue scanning. Since the scan

function stops on channels where a signal is detected, the radio will be

locked. If you want the scan continue, press

▲

key once. When in Full

Scan mode, FS will appear on the bottom line of LCD.

Note that the radio will not transmit, nor will alternative channels be able

to be selected while in Full Scan mode. To restore normal operation

press (F) key or press channel (CH16) key to go to back to VHF screen.

4.3. MEMORY SCAN (MS)

The Memory Scan operates in the same way as the Full Scan, except

that it will only scan channels that have been entered into the Scan

Memory. If no channels have been entered into the memory then this

function will not available. See 4.9, Page 12.

When in memory scan mode, “MS” will appear on the bottom line of the

LCD.

4.4 HIGH/LOW RF OUTPUT POWER SELECTION

Press ▲ or ▼ key to move the ► symbol on the FUNCTION

SELECTION screen to required function “H/L POWER”, then press the

(ENT)

key for selection of low or high power, then the “Hi” or “Lo” will

appear on the bottom line of the LCD.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 50 51

Pas de commentaire

Silva S15 Spécifications Page 11